Foundation cracks

How to Measure and Monitor a Foundation Crack

Updated

Why watch a crack before you fix it?

A crack that leaks but never changes is a sealing job. A crack that keeps moving is a structure question. A few months of notes tells you which one you have, and it is free.

Most cracks in poured walls come from drying. The American Concrete Institute explains that concrete shrinks as it dries, and most of that happens early in the life of the wall. So a crack in an older house that has not changed in years is usually done moving.

What do you need?

  • A pencil or fine marker
  • A ruler or tape with 1/16" marks
  • A phone camera
  • A notebook, or a note taped to the wall

A plastic crack gauge, the kind with crosshairs that you stick across the crack, makes small movement easier to read. It is optional.

How do you measure and mark the crack?

  1. Find the widest point. Hold the ruler across it and note the width.
  2. Draw a short line across the crack at each end, right where the crack stops. Write the date beside each line.
  3. Draw a line across the crack at the widest point, so you measure the same spot every time.
  4. Take a photo with the ruler held against the wall, square on and close up.

The home builders association bands crack widths in its guide to common cracks: hairline to 1/8" is negligible to slight, and 3/16" to 9/16" is moderate. Note which band yours falls into.

How often should you check?

Once a month is enough for most cracks, plus after any big rain, snowmelt or hard freeze. Keep going for at least a few months, and through one wet season if you can.

DateWidth at markReached past end marks?Damp?Notes
Example1/16"NoAfter rainSame as last month

What changes mean you should call an engineer?

  • The crack reaches past your end marks
  • The width grows at your mark
  • One side starts to sit further out than the other
  • The wall begins to bow or lean
  • New cracks appear nearby, especially sideways ones

Any of those point to movement. Our guide to calling a structural engineer covers what to expect from a visit.

What if it stays the same but leaks?

Then it is a leak, and you can seal it. Thin vertical cracks that leak after rain are what injection kits are made for. The how-to for sealing a leaking crack takes you through it, and the crack sorting quiz double-checks the other warning signs.

Common questions